Refrigeration setpoint management across every store.
Setpoints drift. A technician changes one during a service call, a remodel resets a controller, a seasonal change never gets reverted. Across dozens or hundreds of stores, that drift costs energy, product and alarm noise. KalderIQ compares every connected store with the standards you set and shows exactly where it differs.
Why setpoints drift.
Refrigeration controllers hold hundreds of settings per store. They change for good reasons during service, remodels and troubleshooting, and they rarely get changed back. New stores are commissioned by different contractors with different habits. Without a check against a standard, nobody sees the drift until it shows up as a warm case, a nuisance alarm or a high energy bill.
What KalderIQ checks.
- Case and rack temperature setpoints against your configured corporate standards
- High and low alarm limits, including missing thresholds
- Settings that commonly waste energy
- Deviations by store and by piece of equipment, in one report
- Commissioning checks when a store comes online or after a remodel
From finding to fix.
Setpoint reports list each deviation with the store, equipment and current value, so your team or contractor can correct it. Changes to live controllers are made through your approved procedures and permissions, including remote access where you allow it. Analytics findings never change a controller automatically.
Works across a mixed estate.
Kalder applies the same standards across Copeland E2 and E3, Danfoss and Micro Thermo controllers, so stores picked up through remodels and acquisitions are held to the same rules as the rest.
The Kalder products behind it.
Common questions
What is refrigeration setpoint management?
Checking and maintaining the temperature setpoints and alarm limits on refrigeration controllers against a defined standard, across every store, so drift is found and corrected before it costs energy or product.
Does KalderIQ change setpoints automatically?
No. KalderIQ identifies deviations and reports them. Your team or contractor makes changes through your approved procedures and permissions.
Can we set our own standards?
Yes. KalderIQ compares each store with the corporate standards you configure.
Further reading.
See your stores the way our alarm desk does.
A 30-minute walkthrough with someone who knows refrigeration. Bring your store list and controller types; we’ll tell you what connects and where we’d start.